MACHINES AND
ACCESSORIES
Page 15 of 22
6. At this point, the coolant pump is completely assembled, fill the tank with a suitable
coolant liquid, using the hole on the lid of the tank.
Coolant quantity
Fill the coolant tank by a little over half of its capacity, as this amount is sufficient for the
correct operation of the equipment and avoids unnecessary waste of coolant liquid.
7. After filling the tank with the coolant liquid, place it in the
vicinity of the machine on which the pump must be
installed, and then proceed to install the coolant outlet
nozzle onto the machine, securing it using the special bolts,
supplied in the package, as shown in the next figure.
Figure 8 – Fixing the nozzle
Installation of the coolant outlet nozzle
During the installation of the coolant outlet nozzle, pay the utmost attention to not install the
accessory in a position that creates an obstruction during operation, also if possible, pass the
water tube behind the machine tool, so that will not be damaged accidentally.
8. Install the coolant pump control panel next to the control
panel of the machine-tool on which the equipment is
installed, fixing it by means of special bolts (not supplied)
Figure 9 – Control Panel
Control panel installation
Install the control panel in a position that is convenient and easily accessible for the operator
during operation.
fervi.com
