Ferrari Costruzioni Meccaniche GREENCAM TSA-40, Instructions For Use And Maintenance Manual

Page: 12 / 80

OPERATING INSTRUCTIONS AND MAINTENANCE 2020
Pagina 12 di 80
SECTION 3
Handling and use instructions
3.0 HANDLING
Transport by van or truck
If it is necessary to carry the "Greencam" machine, it must be
placed on the transport table in such a way as to use the feet
and fixed by ropes or bands. You will not be moved during the
journey.
Lift up by a forklift
• The operation must be carried out by qualified and
experienced personnel.
• Ensure that the loading capacity o f the trolley is suitable for
the load to be lifted.
• Make sure the forks are long enough. Completely introduce
the forks under the machine frame at the maximum permitted
width.
• Ensure load stability.
• Lift the loa d as necessary and proceed at minimum speed,
avoiding rips or bumps.
Lifting by belts or chains
• The operation must be carried out by qualified and
experienced personnel.
• Ensure that the load capacity of bands or chains and lifting
equipment is suitable for the load to be lifted.
• Harnes s the load by wrapping the straps or attaching the
chains at the point indicated by the appropriate labels (fig.6)
Slowly lift the tool as necessary, making sure that the load is
carefully balanced.
• Do not, under any circumstances, remain in the area below
the machine when lifting and moving.
Fig.6: Lift up through chains
3.1 BEFORE USE
Before starting work, verify that the equipment is perfectly in
order.
The regulation and preparation equipment to working, must
be always followed by equipment in the ground, and with off
and blocked tractor.
3.1.0 INSTALLATION OF THE MACHINE TO THE TRACTOR
To install the machine to the tractor, use the following
instructions. The assembly of the machine is subject
to the presence of a universal three-point attachment on the
tractor.
Then proceed as follows:
•
With Greencam machine in flat position, rearrange the
tractor until the two lower arms of the same result in
correspondence of the two pins on the machine.
•
Switch off the tractor and insert the parking brake.
•
With protective gloves, place the lifting bars at the two
lower points of the weeding machine and insert the bars
into the plugs. Lock the plugs with their safety pins.
•
Lock the two tractor bars with the appropriate tensioners
so as to avoid lateral displacement of the equipment.
•
Hook the adjustable arm of the third upper point by
locking with the appropriate pins and pins and adjust the
length, verifying that the frame of the weeding machine is
parallel to the ground
•
It is absolutely forbidden to interpose between the tractor
and the coupling to manoeuvre the control of the lifting
from the outside.