10
© Ferno Washington Italia. Rel.010916
ITC - Retaining system for incubator
The use of the ITC-HL system requires a minimum of
four trained operators. To remove the ITC-HL system with
incubator, remove all the safety pins holding the anchoring
blocks between the ITC-HL frame and the stretcher together
(see figure 6 and figure 7), open the four lifting handles
(see figure 8), and lift the ITC-HL frame with the incubator,
keeping it parallel to the ground. Always put the handles
back in the starting position when connecting the system to
the stretcher again, as shown in figure 9. If the pins on the
blocks fixed onto the stretcher get in the way, they can easily
be turned by 180°.
NOTE: Slightly loose one of the two fastening screws if the
block cannot be easily moved, as indicated in figure 10.
Figure 10
WARNING
For the assembly of the anchoring blocks, drive
screws fully home using a 5 mm hexagonal head
wrench, as indicated in the figures below.
WARNING
The installation of the incubator must be carried
out exclusively by staff authorised and certified by
the Manufacturer.
Figure 8: Figure 8: Lifting handle OPEN.
Figure 9: Lifting handle CLOSED.
