Fermax PBX EA, User And Installation Manual

Page: 23 / 50

3. Programming of Parameters
3.1. Basic VoIP settings
3.1.1. Choosing a mode and login
It is important to choose a DoorPhone mode first. The
DoorPhone can work in the PeerToPeer mode or SIP server
mode. The mode setting can be made by a relevant switch
(DIP switch see on picture 6). In the SIP server mode is
possible to choose SIP server (external). It can be set in a
configuration interface of the DoorPhone.
Setting values in doorphone to the firm setting make by
DIP switch 3 move to the position off and reboot
doorphone. After reboot system this switch is necessary
return to the position On.
Setting of basic IP address 192.168.1.250
make by DIP switch 4 move to the position
off and reboot doorphone. After reboot
system this switch is necessary return to the position On.
Reboot doorphone it is possible make by double ways - partly turn it off and on again,
or clicks on "Restart", in WEB site is at the entry service.
IP address of doorphone is from the manufacturer (as well as default) setting on
192.168.1.250. If you are at installation in other numbering nets (= NOT BEGINING
192.168.1.xxx) so is necessary setting in feature of protocol TCP/IP in your PC IP
address either temporarily or like alternative configuration e.g . 192.168.1.245 . Then
it is possible setting parameters of doorphone including new IP address and after
reboot VoIP module in doorphone you can attach to WEB sites of the doorphone
already on new IP address.
ATTENTION: DIP switch 3 and 4 must be in position "On", otherwise new IP address
after reboot module is re-write back on starting IP address = 192.168.1.250.
Picture. 6 DIP switch setting
23