Fermax PBX EA, User And Installation Manual

Page: 21 / 50

The switch (code lock) can be controlled by first 10 buttons of DoorPhone. If the
visitor at door presses buttons in such combination that meet the preprogrammed
code and the time among presses is not bigger than the set point, then the
DoorPhone will pick up and close the corresponding switch (if set in m=1 or m=5
modes) to the period given by seting in parameters. Then it will hang up.
2.2.2. DoorPhone with Keyboard
The DoorPhone with keyboard can also include besides the
keyboard up to 26 buttons of direct dialing always behaving as to
be mentioned in (page 18) except the code lock. This one is always
situated on keyboard. After keyboard is connected, the position,
where the keyboard is connected to, should be set in
programming parameter.
The keyboard has two functional buttons
B: (or bell) symbol = once pressing the numerical combination is considered as the
combination for control of the switches. The second button
A: symbol = when pressing the DoorPhone immediately will hang up.
The number selection on keyboard can be executed in two ways:
-
The incoming person is dialing number as to be done on phone - the period
among button presses should be lower than the value given by programming
parameter. After this period the DoorPhone will lift up and dial the given number.
-
On buttons the incoming person is dialing a two-digit number (from 01 to 64),
which represents the memory number, where the 25-digit number is stored
(same as for buttons). The number dialing is managed by Day/Night setting or
mode for two groups of numbers (as described in chapter page 20).
A code Lock:
-
before pressing the code must be preceded by pushing the button with the
symbol B (or bell)
- to enter the two codes are directly behind you, then you must first wait for the
activation of the expiry of "the time between keystrokes", or press the symbol A
and immediately continue squeezing the second code (including symbol B or bell)
21