31
KIN PANEL
ANNEX
6.1. FIRMWARE UPDATES
6.2. REGULATIONS
Radio frequency module. Ec Declaration of Conformity:
FERMAX ELECTRÓNICA, S.A.U. declara que este producto cumple con los requerimientos de:
RED 2014/53/EU Directive “Radio frequency equipment”.
https://www.fermax.com/intl/en/pro/documents/technical-documentation/DT-13-declarations-of-conformity.html
Radio frequency module:
• Frecuencia: 13.56MHz / Potencia máxima: 2,45mW
This device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
o Reorient or relocate the receiving antenna.
o Increase the separation between the equipment and receiver.
o Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
o Consult the dealer or an experienced radio/TV technician for help.
Sometimes it may be necessary or convenient to update a new firmware version because improvements or
corrections have been incorporated into its operation.
FERMAX’s Technical Department periodically informs (through Communications, Technical Bulletins, etc.)
about the release of a new firmware update, as well as the improvements incorporated.
Contact the FERMAX Technical Department if you wish to receive the corresponding update file.
The firmware update is performed via the FERMAX MEET System Upgrading Tool V01.00.exe. The procedure
for updating the firmware with the corresponding update file is as follows:
1.
Start the FERMAX MEET System Upgrading Tool v1.00.
exe.
2.
Browse the PC to find the location of the corresponding
update file.
3.
Indicate the IP of the panels.
4.
Select Upgrade.
The new firmware will be installed, and the panel will
automatically restart.
