TS2000 PRINTERS OPERATION MANUAL
6 – CONTROL COMMANDS
LF
[Name]
Print and line feed
[Format]
ASCII
LF
Hex
0A
Decimal
10
[Description]
Prints the data in the print buffer and feeds one line, based on the current line spacing.
[Note]
This command sets the print position to the beginning of the line.
[Reference]
ESC 2, ESC 3
.
CR
[Name]
Print and carriage return
[Format]
ASCII
CR
Hex
0D
Decimal
13
[Description]
When automatic line feed is enabled, this command operates the same as
LF
; when
automatic line feed is disabled, this command is ignored.
[Notes]
●
This command is effective only it is programmed with such functionality (see
command
DC3 ESC FS GS
).
●
Sets the print starting position to the beginning of the line.
[Reference]
LF
DC3
p
m ton toff
[Name]
Enable digital output
[Format]
ASCII
DC3
p
m
ton
toff
Hex
13
70
m
ton
toff
Decimal
19
112
m
ton
toff
[Range]
<00>H
≤
m, ton, toff
≤
<FF>H
[Description]
Enables the digital output which can be triggered either by an error event or intentionally
The parameter
m
is composed by to nibbles. The high nibble sets the triggering event
while the lower one set the number of complete cycles to be output.
m (hex)
high nibble
m (hex)
low nibble
Function
0
0 to F
No event. Output directly by command
1
0 to F
Output triggered by hardware error
2
0 to F
Output triggered by Vp voltage error
3
0 to F
Output triggered by temperature error
4
0 to F
Output triggered by cutter error
5
0 to F
Output triggered by no-paper error
6
0 to F
Output triggered by platen-opened error
7
0 to F
Output triggered by black mark error
8
0 to F
Output triggered by ticket not picked up error
9
0 to F
Output triggered by paper-near-end error
27/58
