MOUNTING INSTRUCTIONS
SWIVEL MOUNT INSTALLATION
1)
Secure the Swivel Ball to the base of the controller
using the #10 screw.
2)
Attach the swivel ball to the swivel bracket base using
the #10 screw.
3)
Using the #10 screw, secure the two clamps loosely
together.
4)
Place the clamps and screw around the 2 swivel balls.
Tighten the clamp screw, thereby attaching the swivel
bracket base to the mini controller.
5)
Secure the Swivel Bracket to the rear of the controller
(as shown in the diagram).
L-BRACKET INSTALLATION
Note:
The provided L-brackets can be mounted either
way, L-inward or L-outward. The instructions reflect the
default mounting method: L-outward.
1)
Utilizing the provided screws, secure the L-Bracket to
the side of the controller using a Phillips head screwdriver.
2)
Repeat Step 1 on the opposite side of the controller so
both sides have the L-Bracket securely connected.
3)
Place the unit against the intended mounting surface.
4)
Mark the areas where the mounting holes will be drilled.
If the mounting surface is part of the vehicle, make sure
no vital components could be damaged by the drilling
process.
5)
Drill two mounting holes on the mounting surface,
making sure no vital components of the surface are
damaged.
6)
Using customer supplied screws, secure the 4200 Mini
to the mounting surface.
6)
Place the unit against the intended mounting surface.
7)
Mark the areas where the mounting holes will be drilled.
If the mounting surface is part of the vehicle, make sure
no vital components could be damaged by the drilling
process.
8)
Drill two mounting holes on the mounting surface,
making sure no vital components of the surface are
damaged.
9)
Using customer supplied screws, secure the 4200 Mini
to the mounting surface.
OPTION B: SURFACE MOUNT
1)
Mount the U-Shaped Bracket in the desired location
using 2 self-tapping screws. If you wish to use machine
screws, simply drill out the required hole size based on the
size of screw choice.
Important! Make sure not to damage any vital parts of the
vehicle or mounting surface. Do not mount anywhere that
interferes with the vehicle air bag.
2)
Re-attach the control panel head to the U-Shaped
bracket utilizing the factory provided screws.
3)
Connect the RJ45 cable to the RJ45 port located on
the rear of the controller.
TM
FENIEX //
INSTRUCTION MANUAL
WEB //
www.feniex.com
6
