EN
11
4.9 CUTTING CAPACITY
The following tables specify the cutting capacity at 0° and
45° which may be achieved under the normal conditions of
use illustrated in this manual.
MODEL 280
5.3 SUCTION OF DUST RESIDUES (Fig.14)
(OPTIONAL)
The mitre-saw can be connected to an aspirator or a dust
collection bag can be mounted by means of the exhaust
manifold
13
.
The aspirator pipe or the bag sleeve must be secured to the
manifold by means of a band. Users are reminded to empty
the bag or aspirator container and to clean the fi lter regularly.
The air output speed must be equivalent to at least 100
Nm3/h.
For example, “dustbin” type aspirators are suitable.
6
MANUTENZIONE
ATTENTION: Before carrying out any maintenance
operation, unplug from the mains.
6.1 LUBRICATION
The mitre saw is delivered fully lubricated and does not
require any further lubrication.
6.2 REGULAR MAINTENANCE
The regular maintenance decribed above and in the paragraph
below can be carried out by unskilled personnel.
1. Do not oil the mitre-saw, cause cutting must be carried
out in dry conditions (including the cutting of aluminium
and aluminium alloys); all rotating parts are self-
lubricating.
2. During maintenance, wear protective gear if possible
(accident-prevention goggles and gloves).
3. Remove cuttings when necessary both from the cutting
area, work surfaces and support bases.
Use of an aspirator or brush is recommended.
ATTENTION: Do not use compressed air jets!
4. Regularly check blade conditions: if diffi culties should
arise during cutting, have it sharpened by skilled
personnel or replace it if necessary.
5. Periodically, check that the blade comes to a complete
standstill within 10 seconds of releasing the button.
In the event of either of these test returning a negative
outcome, have your machine serviced by an authorized
technician.
6.2 ASSISTENCE
When in need of skilled personnel for special maintenance,
or for repairs, both during and following the guarantee
period, always apply to authorized centres for assistance or
directly to the manufacturer if there is no authorized centre
in your area.
MODEL 280S
MODEL 305S
MODEL 305W
5
ACCESSORIES
5.1 SELECTION OF THE BLADE
The mitre-saw is fi tted with a WIDIA blade:
Ø 280 x foro 30
(280 – 280S)
Ø 305 x foro 30
(305S - 305W)
Contact our Authorised Service Centres located nationwide
for blades having diff erent tooth formations.
5.2 STANDARD ACCESSORIES
This range of mitre saw is supplied complete with the
following accessories
- End stroke shafts: necessary for cutting beams with the
same length
- end stroke guide for upper surface: allows cuts or
notches to be made at a precise, constant distance.
The equipment of series can change depending of
version applied of actual commercial situation.
