Fema M Series, User Manual, Page: 19 / 36

FEMA ELECTRÓNICA . SERIES M . M60-LC
19
At the ‘ Key UP (‘fast access’) ’ (‘ K.uP ’) menu configure which
functions and parameters will be accessible through the ‘fast
access’ menu. Select ‘on’ to activate each function. See sec -
tion
1.12.13
for additional information.
• the ‘
Setpoint 1
’ (‘
ALr1
’) function allows to visualize and
modify the setpoint for alarm 1.
• the ‘ Setpoint 2 ’ (‘ ALr2 ’) function allows to visualize and
modify the setpoint for alarm 2.
• the ‘ Setpoint 3 ’ (‘ ALr3 ’) function allows to visualize and
modify the setpoint for alarm 3.
• the ‘ Stock units ’ (‘ Stck ’) function allows to visualize and
modify the quantity of units defined at the ‘stock units’ pa -
rameter (see section 1.12.6) .
• the ‘ Gross weight ’ (‘ GroS ’) function allows to visualize the
gross weight.
• the ‘ Tare value ’ (‘ tArE ’) function allows to visualize the ac -
tual tare value.
• the ‘ Signal mV ’ (‘ c.MV ’) function allows to visualize the
actual value of the input signal, without scaling. Value is of -
fered in mV.
• the ‘ Exc. voltage ’ (‘ c.EXc ’) function allows to visualize the
actual value of the excitation voltage, measured between
terminals ‘ sense+ ’ and ‘ sense- ’. Value is offered in Vdc.
• the ‘ Exc. current ’ (‘ c.MA ’) function allows to visualize the
actual value of the current provided by the instrument to the
load cell. Value is offered in mA.
• the ‘ Memory of maximum ’ (‘ MAX ’) or ‘ Memory of mini -
mum ’ (‘ MIn ’) allows to visualize and/or reset the actual val -
ue of the maximum and minimum memory.
1.12.15 ‘Fast access’ configuration menu
Key UP
(‘Fast access’)
Gross weight
Setpoint 1
Setpoint 2
Setpoint 3
Tare value
Stock units
Memory of
maximum
Memory of
minimum
Signal mV.
Exc. voltage
Exc. current
The ‘ On power up ’ (‘ on.Pu ’) menu assigns functions to apply
when the instrument restarts after a power loss. See section
1.12.14
for additional information.
• at the ‘ Delay ’ (‘ dLAy ’) parameter configure the time the
instrument waits before starting normal operation. Value be -
tween 0 and 200 seconds.
• at the ‘
tare
’ (‘
tArE
’) parameter configure to ‘
on
’ to activate
a tare every time the instrument restarts after a power loss.
1.12.16 ‘On power up’ configuration
On power up Delay
Tare
Seconds