Fema M Series, User Manual, Page: 13 / 36

FEMA ELECTRÓNICA . SERIES M . M60-LC
13
At the ‘
Auto-tare
’ (‘
Aut.t
’) menu configure the activation val -
ue and stability values to control the automatic activation of
the tare, when weight is removed from the cell. See section
1.12.4 for additional information.
• at the ‘ Activation value ’ (‘ SEt ’) parameter, configure the
working limits for the ‘auto-tare’. The ‘auto-tare’ only ac -
tivates for lower values of reading. Accepts any value be -
tween 0 and 999999. Default value is 1000.
• at the ‘ Stability band ’ (‘ bAnd ’) parameter, configure the
number of counts allowed to consider a signal ‘stable’. The
‘auto-tare’ only activates if the reading fluctuates within this
band of counts. Accepts any value between 0 and 999999.
Default value is 10.
• at the ‘ Stability time ’ (‘ tIME ’) parameter, configure the
minimum time, in tenths of second, for the signal to be
within the stability band to consider it ‘stable’. Accepts any
value between ‘0.0’ and ‘99999.9’. Default value is ‘0.0’.
Value 0 at the stability band and/or 0.0 at the stability time,
disable the ‘auto-tare’ function.
The tare is automatically activated when reading is lower
than the activation value, and the fluctuation of the reading
is lower than the counts defined at the ‘stability band’ for
the time defined at the ‘stability time’.
At the ‘ Maximum tare ’ (‘ MAX.t ’) parameter, configure the
maximum value of reading to allow for a tare to be applied.
See section
1.12.4
for additional information. Accepts any val -
ue between 0 and 999999. Default value is 999999.
At the ‘
Scale factor
’ (‘
ScL.F
’) parameter, configure the value
for the multiplier and the divider. See section
1.12.5
for addi-
tional information. Accepts any value between 0 and 999999.
Default value is 1.
At the ‘
Stock units ’ (‘ Stck ’) parameter, configure the number
of units for the actual weight. See section
1.12.6
for additional
information. Accepts any value between 0 and 999999. De -
fault value is 0 (function disabled).
At the ‘
Mode ’ (‘ ModE ’) parameter, configure the acquisition
mode. See section 1.9.1 for additional information. Default
value is ‘ Standard ’ (‘ Std ’).
Stability time
Auto-tare
Stability band
Activation value
Maximum tare
Advanced conf.
Scale factor
Divider
Multiplier
Standard
Mode
60 Hz
50 Hz
Stock units Units
1.12.7 Advanced configuration menu