Page 8
Brisa
™
electric table base
assembly
step 10: attach control unit
• Place the control unit between the cross channels. Position it so that the
cable from the keypad can reach the control unit and the motor cables can
extend from the control unit to both motors.
• Attach the control unit using the two M5x15 #2 Phillips round head screws.
step 11: make connections and organize cables and cords
While making the following connections, organize the cables and cords using the troughs and the provided
cord clips. The cables and cords must not dangle under the table where they may present a hazard
to the user or may accidentally be pulled from their connections.
• Connect the cable from the keypad to one of the end ports on the control unit,
as shown.
• Connect the motor cables to the ports on top of the control unit and to the short
cable from each table leg.
• Connect the power cord to the control unit.
• Plug the power cord into an AC outlet. Be sure the cord can reach the outlet
when the table is raised to its highest position.
CAUTION:
Do not operate the table until after initializing the system.
See step 12 on the next page.
cord clip
M3.5x16
#2 Phillips
flat head
trough
M5x15 #2 Phillips
round head
control
unit
keypad
cable
motor
cable
motor
cable
power cord
