Page 4
Brisa
™
electric table base
assembly
#8-18x½"
#2 Phillips
flat head
leg cap
shroud
step 3: attach legs to frame
• Remove the cotter pin from each cam lock and save it for use later in this step.
• Position each leg.
— First lower the protrusions on the motor housing into the notches.
— Then push the protrusions back toward the top supports into the narrower part of the notches.
• Route the motor cable on each leg under the frame support, as shown.
• Install the cam lock. With the lever arm upward, insert the long end of the cam lock first, as shown.
• After the cam lock is installed, rotate its lever arm toward the leg until the lever is horizontal. This locks the
leg in place.
• Install the cotter pin to secure the cam lock.
• Check to be sure each leg is securely locked in position.
WARNING:
The cam locks must be in the locked position at all times to secure the
legs in place.
step 4: attach leg caps to shrouds
• Secure a leg cap to the top of each shroud with the self-tapping #8-18x½” #2 Phillips flat head screws.
route motor
cable under
frame support
install cam lock,
long end first
rotate lever
to lock leg
secure
with cotter pin
cam lock
cotter pin
remove and save
position leg
