Page 3
Brisa
™
electric table base
assembly
step 1: position frame on table
With the table top facing down on a soft, clean surface, arrange the frame as shown below. The short end of the top supports must be toward the rear.
• Position the frame side to side.
— Loosen all eight set screws using the 5mm Allen key. Expand or compress the frame so that the top supports are 1" from the edges of the table. There are scribe
marks on the expanding portion of the cross channels; center the longest scribe mark. Then tighten the eight set screws.
• Position the frame front to back.
— With tables that are 24" deep, position the rearmost hole on the top supports 1" from the rear edge of the table. With 30" tables, position the rearmost holes 4" from
the rear edge of the table. This position of the frame will center the feet front to rear when they are installed in step 5.
step 2: screw frame to table
• Use the M4.8x22 #2 Phillips round head screws
(12 screws total).
• Screw through the top supports and cross
supports, as shown.
1" with 24" table
top
support
short end toward rear
cross channel
1"
1"
4" with 30" table
loosen
set screws
M10 x 25
socket set screw
front
rear
feet
will be
centered
front
to rear
center longest
scribe mark
cross support
top support
M4.8x22
#2 Phillips
round head (12)