4
5
240mm (9.5”)
240mm (9.5”)
STEP 2
Adjust the position of the frame before attaching it to the table
• Using two people, place the table top on the base.
• Check that the table top supports on each side are flush to both ends of the
desktop and align to the predrilled holes on the desktop.
• The rear cross channel will be 240mm (9.5”) for 800mm (31.5”) Depth Tops
from the rear of the table.
Rear
Rear
Front
Front
Front
Rear
STEP 1
Preparing for installation using two people
• Place table face down on a soft, clean surface.
• Ensure levers on base are in the upright position.
• Fold out legs until they click, WARNING: Pinch Point! Keep hands and
objects clear when lifting legs.
• Lock legs into place by pushing down on levers.
• Optional: If legs need to be folded, ensure lever is in upright position and
power is unplugged. Pull out pin and carefully guide legs to folded position.
• Lift base out of box and place on table.
• The base arrives adjusted for 1600mm (63”) wide tables. If your table is not
1600mm (63”) wide you will need to adjust the base width 1187 – 1816mm
(47" - 71.5"). See step 1B, otherwise move on to step 2.
STEP 3
Clamping base to table
• Slide clamps on each side of the table.
• On each clamp, tighten the (2) thumb
screws until each click.
INSTALL OPTION 2 - HARDWARE
ACCESSORY INSTALLATION
STEP 1B - Only required if table is not 1600mm (63”) wide
Adjust the cross channels to their final lengths
• Use the 5mm Allen key to loosen the (8) set screws on the inward side of the cross channels.
• Expand or contract the cross channels until flush with both ends of the desk. Free cables as
necessary to allow the frame to adjust.
• Ensure proper alignment to predrilled holes on the desktop.
• Once properly adjusted, use the 5mm Allen key to re-tighten the set screws (8 total).
STEP 2
Adjust the position of the frame before attaching it to the table.
• Check that the top supports on each side are flush to both ends of the desktop and align to the
predrilled holes on the desktop.
• The rear cross channel will be 240mm (9.5”) for 800mm (31.5”) Depth Tops from the rear of
the table.
STEP 3
Attach base to the table
• Use the M6 Phillips round head screws (8 total required) and a Phillips screwdriver.
• The screws fit through guides in the top of the supports. Ensure proper alignment with predrilled
holes on the desktop.
• Using two people, flip the Base and Table upright.
• Attach clamp covers to each side. Start by placing the smaller piece on the inside of the clamp
bracket. Align the larger piece and apply pressure to secure.
STEP 1
Cable Management
• Partially drive (4) Philips Head screws into the pre-drilled holes located towards the back of
the table.
• Hook the cable tray key slots onto the screws and slide the tray to lock it in place. (Note: the
open end of the cable tray should face the back of the table.)
• Tighten the (4) Philips Head screws to secure the cable tray.
• Use the additional provided cable management as needed.
• Cables must not interfere with table operation.
• Cables must not interfere with the user.
