10
These signs will give
advice for your safety.
Before leaving our factory every machine is
thoroughly tested.
Follow our instructions strictly and your machine will
give you long service in normal operating conditions.
MANDATORY
INDICATION
I N F O R M AT I O N
INSTRUCTION
WARNING
PROHIBITION
1
FEATURES
Use: Water cooled cutting of tile materials.
Blade Capacity: Rim 8” (200 mm) - Bore 5/8” (15.9mm)
Depths of Cut (Maximum): 1” (25mm) @ 90
°
;
0.7” (17mm) @45
°
Cutting Width With Guide At 90
°
: 6” (15 cm)
Length of Cut: Unlimited
Blade RPM: 3400 (6500 maximum, no load)
Power: 3/4 HP (560W)
F.L. Amps: 9A @ 115V and 4.5A @ 230V
Motor Protection: Thermal overload with manual
reset.
Weight: 35 lbs (16 kg)
Dimensions (L x W x H):
14.5” (37 cm) x 13.5” (34 cm) x 10.25” (26 cm)
Cutting Table: 12” x 13” (31 cm x 33 cm)
Tank Capacity: 1.2 Quarts (1 litre)
Blade Cooling: Partial immersion of blade in water
(For information, contact your Felker supplier)
Before starting up the machine, make sure you
read this entire manual and are familiar with
the operation of this machine.
The working area must be completely clear,
well lit and all safety hazards removed.
The operator must wear
protective clothing
appropriate to the work he
is doing.
Any persons not involved in the work should
leave the area.
Use only blades marked with a maximum
operating speed greater than the blade shaft
speed.
2
MACHINE SET-UP PROCEDURES
Your Tile Magic™ tile saw is factory assembled prior to
shipment to ensure accurate cuts when the saw is
delivered. However, since FELKER cannot control
rough handling during shipping, it is suggested that the
following procedures be followed:
·
Remove the saw from the shipping carton
·
Check the carton and all packing filler for any loose
parts.
3
MOUNTING THE BLADE
1. Disconnect the saw from power source.
2. Remove the splash guard (Item 16) by loosening the
knob (Item 18) and sliding the guard up and off.
3. Loosen the two table locking knobs (Item 24), then
remove the table assembly (Item 19).
4. Before mounting the diamond blade, verify that the
flanges (Item 11) are free from dirt and grease.
IMPORTANT: Make sure the blade is properly
installed. Failure to do so will result in
damage to the blade.
5. Install the blade for counterclockwise (CCW) rotation.
Check the blade for the direction arrow.
6. With the blade properly seated (pushed against the
inner flange), install the outer flange and tighten with a
wrench. Never hand tighten!
7. To reassemble, simply reverse the steps 2 and 3
above.
4
OPERATING PROCEDURE
1. Fill the tank with clean water through the hole in the
cutting table. Check the water level through the
overflow hole in the tank side.
2. During the operation, set the blade guard as close to
the material as possible in order to avoid water
splash.
3. Plug the power cord into the proper current outlet
using as short of a cord as needed to avoid
unnecessary voltage drop. No. 16 gauge or larger is
recommended.
WARNING: Keep the water clean and make
certain the water level is up to the overflow
hole.
