![background image](http://html1.mh-extra.com/html/feig-electronic/tst-fu3e/tst-fu3e_start-up_548930015.webp)
TST
Startup
FU3E
FEIG ELECTRONIC GmbH
Page 15 of 29
FU3E_Inbetriebnahme_7_GB.doc
7 Startup...
WARNING
Before you start up the controller you have to check the electrical connections and the correct
position of the plug in cards.
After the start up you must check all the safety devices and their functions.
7.1 ... using absolute or incremental encoders
1. Open CALIBRATE mode by briefly pressing the
Å
STOP key.
2. Go to Door-CLOSE position by pressing the
À
CLOSE key and save by pressing the
Å
STOP-key for
approx. 3 sec.
IMPORTANT
If the door does not move, the motor does not have enough power. Use Boost
(increases power at slow speeds) to give the motor more power. (see Section 7.4)
3. Go to Door-OPEN position by pressing the
¿
OPEN key and save by pressing the
Å
STOP-key for
approx. 3 sec.
IMPORTANT
If the door does not move, the motor does not have enough power. Use Boost
(increases power at slow speeds) to give the motor more power. (see Section 7.4)
)
When the door then moves in automatic mode, the pre-limit switches and ramps are automatically set.
Is this function not active the pre limit switches and limit switch bands have to set manually, if they are not
pre set. See “Expanded Startup” for this.
7.2 ... using mechanical limit switches
1. Go to approx. 50cm before the closed position by pressing the
À
CLOSE-key.
IMPORTANT
If the door does not move, the motor does not have enough power. Use Boost
(increases power at slow speeds) to give the motor more power. (see Section 7.4)
IMPORTANT
The distance depends greatly on the door type and the speed; increase this value
for fast moving doors.
If the door moves in the wrong direction: wrong motor rotary field, turn off controller and reverse
the 2 motor wires.
2. Set lower pre-limit switch so that it just trips
3. Press
À
CLOSE-key to bring door to approx. 10cm from the closed position.
IMPORTANT
The distance depends greatly on the door type and the speed; increase this value
for fast moving doors.
4. Set lower pre-limit switch so that it just trips
IMPORTANT Do not travel past the limit switch in the end positions!
5. Press
¿
OPEN-key to bring door to approx. 50cm from the opened position
IMPORTANT
If the door does not move, the motor does not have enough power. Use Boost
(increases power at slow speeds) to give the motor more power. (see Section 7.4)
IMPORTANT
The distance depends greatly on the door type and the speed; increase this value
for fast moving doors.