OBID i-scan
®
Application Note
RFID-Tunnel
FEIG ELECTRONIC GmbH
Page 35 of 54
N70101-2de-ID-B.doc
E N G L I S H
2.2.2 Connecting the antenna conductor
Depending on the antenna conductor the tuning board ID ISC.DAT has to be connected as de-
scribed in the following figures.
The shielding of the coax cable could be clamped direct under the clamp of the ID ISC.DAT or the
shielding can be soldered with the contact areas of the board. (see Fig. 1
Fig. 2)
Fig. 1
Fig. 2
.
Copper pipe has to be pressed flat at the connecting points and the necessary mounting holes
drilled. The pipe endings must coated in solder to prevent the oxidation of the contact area. (see
Fig. 3)
Fig. 3
Summary of Contents for OBID i-scan RFID-Tunnel
Page 29: ......
