OBID i-scan
®
Application Note
RFID-Tunnel
FEIG ELECTRONIC GmbH
Page 47 of 54
N70101-2de-ID-B.doc
E N G L I S H
3.1.6 Tuning the RFID-Tunnel
Before tuning the antennas, you must quit the ISOStart software. Then the RFID-Tunnel can be
tuned as follows:
Step
Action
Note
1
Start “DATuningTool” software
2
Select “Detect Reader...”.
In the „Detect Reader“ window
select the interface (COM-Port
1, BusAdr. 0) and then select
“Detect”.
3
Use „Settings“ to enter the
configuration:
Dual Mode,
Number of Gates 3
Click on “with Multiplexer“
Number of Tuning Iterations 3
4
Activate „Start Tuning“ and
wait until the tuning process is
finished.
...
...
5
The tuning status is displayed
after each tuning pass.
After successful tuning all
antennas of the gates are
shown in green.
Red shown antennas are not
tuned.
6
If this does not succeed on
the first try, start the process
over again by clicking on
„Start Tuning“
After successful tuning, close the DATuningTool again.
Summary of Contents for OBID i-scan RFID-Tunnel
Page 29: ......
