OBID
®
i-
scan
Montage
ID ISC.LR200
FEIG ELECTRONIC GmbH
Seite 20 von 50
M00601-4de-ID-B.DOC
D E U
T
S C
H
4. Bedien- und Anzeigeelemente
4.1. LED
Tabelle 4.1-1 zeigt die Konfiguration der LED.
Kurzzeichen
Beschreibung
LED V1 (grün)
"RUN-LED"
-
Signalisiert den ordnungsgemäßen Ablauf der
internen Reader-Software
-
Blinkfrequenz ca. 1 Hz
LED V2 (rot)
Diagnose 1: RF-Kommunikation / EEPROM-Status
-
Signalisiert durch ein kurzes Blinken die fehlerfreie Kommuni-
kation mit einem Transponder auf der RF-Schnittstelle
-
Blinkt abwechselnd mit V1 nach dem Reset im Anschluß an
ein Software-Update
-
Blinkt abwechselnd mit V1 falls nach einem Reset ein Daten-
fehler beim Lesen der Parameter auftrat
LED V3 (rot)
Diagnose 2: Host-Kommunikation
-
Signalisiert durch ein kurzes Blinken das Senden eines Proto-
kolls an den Host auf der RS232/RS485-Schnittstelle
LED V4 (rot)
Diagnose 3: Re-Reads im Buffered Read Mode und Scan Mode.
-
Zeigt im Buffered Read Mode und im Scan Mode Re-Read
Vorgänge auf dem RF-Interface an. Nur bei Verwendung von
Tag-it und ISO Transpondern.
LED V5 (rot)
Diagnose 4: Reader-Initialisierung / RF-Fehler
-
Leuchtet während der Reader-Initialisierung nach dem Ein-
schalten bzw. nach einem Reset.
-
Leuchtet bei einem Fehler im RF-Teil des Readers. Der Feh-
lertyp kann per Software über die RS232/RS485-Schnittstelle
ausgelesen werden
Tabelle 4.1-1: Konfiguration der LED
Summary of Contents for OBID i-scan ID ISC.LR200 Series
Page 27: ......