OBID
®
classic-pro
Manual
ID CPR30.xx
FEIG ELECTRONIC GmbH
Page 26 of 126
H01114-0e-ID-B.docx
ISO14443-DRV:
Defines the ISO 14443 Transponder types that are read/write operated by the Reader.
Reading of the UID is also possible if the driver is inactive, because of the standardized
ISO14443 access conditions.
If more than one Transponder driver is activated The Reader attempted by means of some
indications to decide about the Transponder type.
To guarantee that the Reader only processes the correct Transponder type the not required
drivers should be disabled.
Byte:
2
3
Bit:
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
0
Driver
0
0
0
0
0
0
0
0
0
0
0
0
L4
C
B
0
b0:
Driver for the Transponder type is disabled
b1:
Driver for the Transponder type is activated
B:
Driver for my-d proximity SLE55Rxx
C:
Driver for NFC Tag-Type 2 (e.g. mifare Ultralight, my-d move, etc.)
L4
Driver for ISO14443A, Part 4 compatible Transponders
ISO14443 BIT RATE:
This parameter defines the highest Bit-Rate which should be used by the Reader. The ac-
tual used Bit-Rate depends on the capabilities of the present Transponder. If the adjusted
Bit-Rate is not support by the Transponder the Reader select the highest supported Bit-
Rate of the Transponder.
Bit:
7
6
5
4
3
2
1
0
Function
Tx BIT RATE
Rx BIT RATE
-
-
-
-
TX BIT RATE
Used for bit rate selection from Reader to Transponder
b00:
106 kbit / s
RX BIT RATE
Used for bit rate selection from Transponder to Reader
b00:
106 kbit / s
ISO14443 STUPT
(1 ... 255 * 5 ms = 5 ms ... 1,275 sec)
:
The Startup Time defines a delay-time which is required by a ISO14443 Transponder for
startup after the RF-Field was switched on (e. g. after a command [0x69] RF Reset).
