EN
Comissioning
MWD BPC-H / MWD BPC-HU
FEIG ELECTRONIC GmbH
36/74
MWD_BPC-H-HU_ver4_Manual_rev0_mul
5
Comissioning
Up to four motion detectors may be connected.
F
or specifications of the CAN interface (max. cable length, cable specification, etc.), refer to the
instructions of the door controller used!
5.1 Connecting the motion detector
The following example shows a bus with four motion detectors.
1. Connect the motion detector cable with one
another using the snap-in connectors
(Figure 2, Pos. 1-4).
2. Attach the accompanying plug on the open snap-
in connector of the last motion detector
(Figure 2, Pos. 4) with terminator.
Figure 2: Bus connection
5.2 Connecting to the door controller
T
he system must be disconnected from the power supply during the
installation.
5.2.1 Connect motion detector to door controller
1. Connect the wires of the CAN connection cable
to the terminal X28B as follows:
G -> blue
CL -> black
CH -> white
+ -> brown
Figure 3: Terminal X28B
2. Connect the first motion detector to the door
controller (Figure 4, Pos. 1).
3. Switch on the door controller and test the
operational readiness of the motion detector
according toTable 2.
Figure 4: Connecting to the door controller
blue
black
white
brown
CAUTION
