20
ORIGINAL INSTRUCTIONS
•
Only a Flashing RED Light (with battery inserted)
indicates the battery pack is too hot.
You should let the battery pack cool down for approximately 30 minutes before attempting to
recharge.
•
A RED and A GREEN light flashing alternatively (with battery inserted)
indicate the
battery pack is defective and needs to be replaced. Please contact authorized service
personnel or dispose of the defective battery in the method explained in this manual.
WARING:
Use this charger ONLY to charge the supplied battery or additional purchased
batteries that are specifically designed for this tool.
WARNING:
Failure to follow the correct procedure when charging batteries will result in
permanent damage.
Note:
Normal charging time is approximately 35minutes for a recently discharged 2.0Ah
capacity battery.
However, if the Battery has been left in a discharged state for some time, it may take
Additional time to charge.
Note:
Make sure the Battery and Battery Charger are lined up correctly. If the Battery does
not slide on to the Battery Charger easily, don’t force it. Instead, remove the battery; check
the top of Battery and the Battery Charger slot are clean and undamaged and that the
contacts are not bent.
IMPORTANT:
When a low charge level is indicated, the tool may stop operating while in use,
which is dangerous when operating a circular saw. Always ensure the battery pack has a
good charge level.
When the battery is full charged, the battery charger will stop charging (switch to stand by).
