4. The upper pedal (fig.12 B & fig.13 B) will be released from the connection (fig.12 E).
5. Raise up the engine part to release attachment.
To Connect Engine part with Attachments (Sweeper / Snow thrower head)
1. Put the sweeper / snow thrower head on an open area.
2. If you are going to connect sweeper head, please make sure that both caster wheels (fig.14 B) are on their
highest position (the wheels cannot touch the ground).
3. Hold the handle of the engine part, and move it towards the attachment.
4. Lower the engine part to make the bar (fig.12 C) go into the two hooks (fig.12 D) to interlock gears of two parts.
You will hear an audible “CLICK”.
5. Make sure the two gears are in right position, then press the upper pedal (fig.12 B) towards the link (fig.12 E).
You will hear an audible “CLICK”.
6. If you are connecting snow thrower head, it’s OK for working now.
7. If you are connecting sweeper head, you have to continue the following steps:
a) Remove the direction bar (fig.11 C) from the hook (fig.11 B).
b) Remove the pin (fig.11 A) on the direction bar (fig.11 C).
c) Press the direction bar (fig.11 C) to the hole on the sweeper head.
d) Put the pin (fig.11 A) into the direction bar (fig.11 C).
Then your sweeper is workable now.
17
Summary of Contents for FBAE200
Page 16: ...16 ...
