Feider Machines AIRWIN1000W, Instruction Manual

Page: 19 / 32

19
• We recommend 1 -2 litres of the appropriate solvent-based cleaner when performing cleaning
procedure
Cleaning the Unit
IMPORTANT! The cleaning process must be followed immediately after use to prevent paint
from drying inside the pump and hose. Failure to follow the cleaning instructions promptly may
permanently seize the paint sprayer and automatically void the warranty.
1. Set the Prime/Spray Switch (11) to the “PRIME” position (Fig.10a).
2. Place the Suction Hose (16) into a bucket of appropriate cleaning solution. Place the Return
Hose (13) into an empty bucket (Fig.10b).
3. Turn ON the machine by pressing “I” on the On/Off Switch (10) (Fig.10c).
Check the Return Hose (13) and wait for a constant stream of cleaning solution to pass out of it.
4. Set the Pr
ime/Spray Switch “SPRAY” position (Fig.10d).
5. Aim the Spray Gun (6) into an empty bucket, then squeeze and hold the Trigger (3) until most of
the paint is removed from the Spray Hose (1).,
6. Lock the spray gun Trigger (3) (Fig.10f).
7. Rotate the Spray Tip (5) 180
0
towards the Spray Gun Handle(7) (Fig,l0g).
8. Unlock the spray gun Trigger (3) and hold the Trigger (3) to spray the cleaning solution through
the system (Fig.10h). Continue spraying until only cleaning solution is ejected from the Spray Tip
(5). Add more cleaning solution if all the paint has not been removed.
NOTE: If the cleaning solution bucket becomes cloudy with paint during this cleaning process, skip
to section “Cleaning the Suction Hose Filter”. Once the Suction Hose Filter (15) and Spray Hose (1)
are clean, re-assemble them and repeat steps 4 to 8 in this section.
9. Set the Prime/Spray Switch (11) to the “PRIME” position (Fig. 10i).
10. Switch OFF the machine by pressing “O” on the On/Off Switch (10)(Fig.10j).