Feider Machines AIRWIN1000W, Instruction Manual

Page: 9 / 32

9
5. TECHNICAL SPECIFICATIONS
Voltage and frequency 230-240
V˜ 50 Hz
Power 1010 W
Flow rate 1.5 L/min
Maximum pressure 22.7MPa
Net Weight 7.2 kg
Temperature Min.10°C/ Max 40°C
IP(Ingress Protection) IPX0
Insulation class II
Guaranteed sound power level 110dB(A)
6. CONTROLS AND FUNCTIONS

ON/OFF Switch (10):
The ON/OFF Switch (10) turns the power to the sprayer ON (“I”) and OFF (0”)

Prime/Spray Switch (11):
The Prime/Spray Switch (11) directs fluid to the Spray Hose (1) when set to SPRAY or to the
Return Hose (13) when set to PRIME. The Prime/Spray Knob is also used to relieve pressure
built up in the Spray Hose (refer to Pressure Relief Procedure ).

Pressure Gauge (8):
Optional accessory that identifies the amount of force the pump uses to push the fluid through
the Spray Gun (6).

Suction Hose (16):
Fluid is drawn through the Suction Hose (16) into the pump.

Return Hose (13):
Fluid is sent back through the Return Hose (13) to the original container when Prime/Spray
Switch (10) is in PRIME position.

Suction Hose Filter (1 5):
Strains the spray material to prevent the system from being clogged.

Spray Gun (6):
Controls the delivery of the fluid being pumped.

Spray Hose (1):
Connects the Spray Gun (6) to the pump.

Lance (1 9):
Optional accessory that can be attached to the end of the Spray Gun (6) to spray hard to reach
areas.
7. MATERIAL / PAINT SELECTION
Do not use textured wall paints or coatings as this will block the spray gun tip and
damage internal components of the Airless Spray Station.
Although a large number of paints and materials can be sprayed, some cannot. Please check the
manufacturers’ recommendations before purchasing paint.