F E I B A O V E L O X X L
20
Figure 118
119.
Plan how you want to install your ECU, solenoids,
and fuel shut off on this tray. Be aware of the need to
plug your data terminal in, and the need to get to the
manual shutoff valve.
Figure 119
120.
Make up mounts as required, and holes for fuel
lines and wires.
Figure 120
121.
Put a small plywood block at each forward bottom
corner to mount the tray. The center ply block is a
mount for the fuel shut off.
Figure 121
122.
Sand the tray and paint it.
Figure 122
123.
Plumb and wire the equipment according to
your engine manual. Note you may need lines long
enough to reach the engine in the rear of the model.
Figure 123
124.
Install the tray with two screws as shown. You
may want to glue two small blocks to the former to
support the rear of the tray. Connect the engine
electrical to the ECU.
Figure 124
125.
Install your fuel pump and connect it to the
UAT.
Figure 125
126.
Run the fuel and gas lines into the engine.
Figure 126
Summary of Contents for Velox XL
Page 25: ...25...
