F E I B A O V E L O X X L
19
111.
Slit some airline tubing and CA it around the
edges of the hole to give it a smooth edge.
Figure 111
112.
Slide the engine into place and mark as required
for holes for fuel, gas, and electrical lines.
Figure 112
113.
Cut these holes and line them with slit airline or
rubber grommets to keep the lines from being abraded.
Figure 113
114.
Carefully align the engine and mark the mounting
holes.
Figure 114
115.
Drill pilot holes for the engine mounting screws.
Be sure not to drill too far and come out the bottom of
the fuselage.
Figure 115
116.
Mount the engine using screws and washers.
Vacuum the engine bay carefully to remove any
debris.
Figure 116
117.
There are many options for setting up your
electronics. The best way is to make a second tray to
go behind the cockpit.
Figure 117
118.
Make up a plywood tray as shown, approx.
125mm deep, 180mm at the rear edge, and 155 at
the front. Test fit it into the fuse.
Summary of Contents for Velox XL
Page 25: ...25...
