Fei Bao Velox XL, Assembly Manual

Page: 7 / 25

F E I B A O V E L O X X L
7
15. Connect the two lower nipples on the door cylinders
with this new harness.
Figure 15
16. Run the lines from the rear door cylinders forward
through the middle of the fuse and connect them to the
front cylinder y connectors as shown.
Figure 16
17. Use your hand pump to extend both main retracts.
Check and tighten all bolts with the provided wrenches.
Figure 17
18. Add lengths of airline to the retracts. The ones to the
outer nipples need to be 20 inches long, the side
nipples 12 inches long.
Figure 18
19. Slip the retracts into place and secure with screws.
Be sure to not pinch the airlines.
Figure 19
20. Connect the lines from the retracts with y connectors
and run line forward to the nose like you did for the
door cylinders.
Figure 20
21. Connect these lines to the nose gear lines, unless
you are using a valve that provides dual outputs for
nose and main gears.
Figure 21
22. Secure the airlines to the retract frames with a tie
wrap on each retract. Be sure not to pinch or kink the
lines.
Figure 22