Fei Bao Velox XL, Assembly Manual

Page: 11 / 25

F E I B A O V E L O X X L
11
47. Add a pair of servo mounts to one servo, and a link to
one horn. This will be a dummy rig to establish the
location of each control horn.
Figure 47
48. Use your rig, a ruler, and a marker to locate and mark
where each horn will go. Be aware of the servo horn,
and allow for the offset of the ball link.
Figure 48
49. Cut a slot for each horn using a sharp exacto. It does a
neater job than power tools for this, and only takes a
few minutes.
Figure 49
50. Box each slow in with tape as shown.
Figure 50
51. Coat the bottom of each horn with hysol. Make sure
the holes are filled with glue.
Figure 51
52. Fill the slots with hysol also. then fair the horns in with
a small fillet of glue.
Figure 52
53. Smooth the fillet with your finger, then remove the
tape and you will have a neat job.
Figure 53
54. You may use tape to make sure the horns remain
upright while drying. Put all these surfaces aside to
dry overnight.
Figure 54