FEI BAO Mirage 2000
Apr 14
8
As with the elevon, remove the servo cover from
the slat openings and fit your choice of servo
using the mounting hardware supplied.
Locate the two slat pushrods one short and
one a bit longer. Fit the pushrod to the servo
arm and put through the opening in the front
of the wing. Pull the slat forward and fit the
clevis over the horn, then slide the servo into
wing.
Given the space in the wing only a short
trial and error to get the rod lengths correct
atchbox is used to drive the four servos to
portant that there is no binding when the slat is retracted as
and may cause a servo to malfunction or
Remove the main undercarriage and check
that all bolts are secure and apply loctite if
necessary. Remove the axle and grind a
small flat on the shaft where the grub
screw secures the shaft as an added
measure of security.
m
servo arm can be used to ensure there is no
binding on the upper wing surface.
Do this for both servos, it will take some
for both servos to ensure even travel and no binding.
It is recommended that a power box or m
fine tune the travel, it is im
this will increase the load on the system
drain the batteries prematurely, either is undesirable.
Attach the brake airline and secure to the
ain oleo with clips or cable ties (not
supplied) and refit the undercarriage.
