FEI BAO Mirage 2000
Apr 14
6
Using a straight edge line up the servo
with the intended position of the
rudder horn. Once marked carefully cut
a slot in the rudder to accept the horn,
ensure that the horn is in line with the
servo arm and that the hole in the horn
is positioned over the hinge line. Using
a high strength glue like Hysol or
Aeropoxy glue the horn into the rudder.
(Note: The photos show two horns used,
only one is supplied and is sufficient for
this task.)
Connect all linkages and check for smooth operation with no binding.
Wings
As for the Rudder, check for adequate
movement of the elevon with no binding and if
insufficient remove the hinge pin, located at the
wing tip, and shape the rear of the wing to
ensure adequate movement of the control
surface, refit the hinge pin once satisfied.
arm
Carefully mark the position of the
fences on the top of the fin and cut
a small slot. Using hysol or similar
glue the fences to the top of the
fin.
