8
SET
-
UP PROCEDURE SUMMARY...
All operational parameters may be set via
the communication link. However, there are occasions where communication parameters
must be set before communication with the unit is possible. To avoid this situation, the
unit supports a very limited set
-
up facility.
To enter the set
-
up mode, the push
-
button
SW1
situated at the back of the terminal
should be pressed and held for five seconds; after which time the unit bleeps and starts
to cycle through the various set
-
up options.
NOTE
: Communication with the unit is disabled when in set
-
up mode.
The cycled sequence is:
•
Application Identity
•
Comms Identity
•
Comms Interface
•
Comms Rate
•
Comms Term Tx
•
Comms Tx Delay
•
Comms Activity Gap
•
Full Initialise
•
Demonstration
•
Diagnostic
•
Restart
Once the desired option is shown,
SW1
should be pressed.
When '
Full Initialise
' is selected, a '
verify
' prompt is shown. If carried out, all data in the
terminal is discarded; and it is returned to its factory default state.
When '
Demonstration
' is selected, the unit cycles through a number of possible demon-
stration modes, as numeric codes. A value of zero represents 'do not load'. Once a value
other than zero has been selected, it is actioned on the next power
-
up
-
And, once done,
the value is reset to zero. Currently supported values are:
1
. Basic autoswipe, barcode, no keyboard support
2
. Basic autoswipe, magstripe, no keyboard support
3
. Basic autoswipe, weigand, no keyboard support
To exit the setup mode,
'Restart'
should be selected; at which time the new parameters
will become active.
COMMISSIONING THE TERMINAL
