3
This guide provides the information necessary to install a TR
-
1000 Terminal. It includes
mounting and cabling information, and instructions to enable the terminal to be
commissioned using it's built
-
in set
-
up facility. Please contact your dealer or Feedback
Data technical services department if you require information about FAMS networks, or
need assistance with programming the terminal.
The terminal is usually installed as part of a network, using a Network Interface, Terminal
Server or LAN to connect several terminals to a host computer. Alternatively a single
terminal can be connected to the RS232 port of a computer, either directly or via a
suitable modem. Each terminal will require a switched mains power outlet and CAT5 or
equivalent unshielded twisted pair (UTP) cable to connect the terminal to the network or
host computer.
Please read this guide before installing the terminal.
LOCATING THE TERMINAL...
Site the terminal indoors and away from extremes
of heat, dust, vibration and fumes. It should be protected from excessive condensation,
hosing and direct sunlight. Choose a location that allows room for normal use and access
for maintenance.
Mounting dimensions are shown below:
CABLING...
Cabling can enter the terminal from the back or through the apertures
provided. The power inlet is situated at one side and the communications cabling near
the middle.
External dimensions of TR
-
1000 terminal
INTRODUCTION
