25
Navigator Lightbar
Installation, Operation, and Service Instructions
Figure 8
Navigator (25-inch) with the end dome disassembled
BULKHEAD LOCKS DOMES
TOGETHER AND FORMS A
SEAL WITH DOME GASKETS
PARABOLIC MIRROR
NAMEPLATE
QUADRAFLARE STATIONARY LIGHT (1 OF 2)
CHANNELS GRIP THE
ALUMINIM EXTRUSION
ROTATING LED HEAD (1 OF 2)
BULKHEAD
ASSEMBLIES ARE SECURED
TO EXTRUSION WITH #10,
TYPE B TORX SCREWS
LIP SEAL
ALUMINUM EXTRUSION
1/4"-20 PAN-HEAD SCREWS (2)
Installing Domes and Bulkheads
To install a dome:
1.
Insure that a bulkhead is in place on the aluminum extrusion to accept the edge of the dome.
2.
Slide the domes and bulkheads onto the aluminum extrusion. Ensure that the edge of each dome is fully
seated in the bulkhead.
3.
Strike the end of the end dome with your hand until it is fully seated in the bulkhead.
4.
Secure the name plate to the end dome with the two 1/4 in x 20 pan-head screws.
Troubleshooting the Lightbar
This section provides troubleshooting assistance for common problems. If you have any questions left
unanswered, call the Federal Signal Service Department at 1-800-433-9132, 7 a.m. to 5 p.m., Monday through
Friday (CT).
Summary of Contents for Navigator Lightbar
Page 2: ......
