Federal Signal Corporation Navigator Lightbar, Installation, Operation And Service Instructions

Page: 14 / 32

14
Navigator Lightbar
Installation, Operation, and Service Instructions
Figure 3 All-rotator power distribution board
J13
J3
J1
J5
J7
J6
J2
J8
J14
J9
J10 J11
MINUS BLACK
20000160
J15
UNIVERSITY
FEDERAL SIGNAL
J16
PMTH2
FF
FR
90
120
J4
J12
FF FR 90
120
FF FR 90
120
FF FR 90
120
FF FR
90
120
FF
120
1
2
3
4
5
6
7
FF
FR
90
120
FR
90
3 1
4
1 2 3
2
CORPORATION
PARK, IL
GREEN LEFT ALLEY ORANGE RIGHT ALLEY
WHITE
REAR CUT YELLOW WHITE LIGHT
GRA
Y
FLOOD VBA
T+
RED
PMTH1
LEGENDS FOR LIGHTHEAD JUMPERS J8 TO J14
120 = ROTATE AT 120 RPM
90 = ROTATE AT 90 RPM
FF = FLOOD FORWARD (FACTORY CONFIGURED)
FR= FLOOD REARWARD (FACTORY CONFIGURED)
J15 CONNECTOR:
ALLEY LIGHTS
REAR LIGHT CUTOFF
WHITE LIGHT
J16 CONNECTOR:
+12 Vdc POWER
FLOOD LIGHTS
The selectable options are:
Rotation speed
When power is applied to the lightbar, the rotator lights rotate at either 90 RPM or 120 RPM. These functions are fixed
while power is supplied to the lightbar. To select a rotation angle, move the jumper on the power distribution board
across the pairs of pins labeled
90
or
120
.
White light flood
When +12 Vdc is applied to the
GRAY
flood wire in the lightbar, the rotator stops and the reflector faces either
forward or rearward with the LEDs changing to white. The determination and configuration of whether a rotator
should flood is made at the factory when the lightbar is assembled. For a rotator to flood when the flood wire is
activated, the jumper must be placed in the
FF
(Flood Forward) or
FR
(Flood Rearward) position on the power
distribution board.
Determining the Mounting Location and Wire Routing
LOCATING OPERATOR CONTROLS: The controls for the light system must be located so that the
VEHICLE and CONTROLS can be operated safely under all driving conditions.
AIRBAG DEPLOYMENT: Do not install equipment or route wiring in the deployment path of an airbag.
Failure to observe this warning will reduce the effectiveness of the airbag or potentially dislodge the
equipment, causing serious injury or death.
SEAT REMOVAL PRECAUTION: If a vehicle seat is temporarily removed, verify with the vehicle manufacturer
if the seat needs to be recalibrated for proper airbag deployment. Failure to follow this warning cause
serious injury or death.