Informer Series Tone Alert Receiver
1
Safety Message
Safety Message
It is important to follow all instructions shipped with this product. This
device is to be installed by trained personnel who are thoroughly
familiar with the country electric codes and will follow these guidelines
as well as local codes.
Listed below are important safety instructions and precautions you should follow:
Read and Understand
Read and understand all instructions before installing or operating this product.
Adhere to all warnings and operating instructions.
Proper installation, placement, and testing are required to ensure the unit is able
to perform as intended. Perform installation, placement, and testing after the
installer has read and understood this manual.
Installation Considerations
Do not use near water; for example, near a bathtub, washbowl, kitchen sink,
laundry tub, in a wet basement, or near a swimming pool, rain, or similar
environments.
Mount to a wall only as specified in this manual.
Place away from heat sources; such as, radiators, heat registers, stoves, or other
accessories that produce heat.
Do not exceed maximum accessory relay output rating of 30 VDC, 5 Amps.
Connect the Informer TAR to a 9 VDC, 500 mA., Class 2 wall transformer as
provided with the unit. Contact your authorized service center if a replacement is
required.
Route power supply cords so they are not likely to be walked on or pinched by
items places upon or against them, pay particular attention to cords at plugs.
Locate an outdoor antenna away from power lines.
If an outside antenna is connected to the receiver, make sure the antenna system
is grounded in order to provide protection against voltage surges and built up
static charges. Article 810 of the National Electrical Code, ANSI/NFPA 70,
provides information with regard to proper grounding of the mast and supporting
structure, grounding of the lead-in wire to the antenna-discharge unit, size of
