7
Safety Messages
Setup, Program, and User Manual
Federal Signal www.fedsig.com
Safety Messages
It is important to follow all instructions shipped with this product. This device
is to be installed by trained personnel who are thoroughly familiar with the
country electric codes and will follow these guidelines as well as local codes and
ordinances, including any state or local noise control ordinances.
After installation, service, or maintenance, test the system to confirm that it is operating
properly. Test the system regularly to confirm that it will be operational in an emergency.
Each Informer device has its own Installation Manual. See fedsig.com for online manuals.
General Description
Introduction
This manual describes how to set up, configure, program, and use Informer-IP devices.
Each Informer device has its own Installation Manual. See fedsig.com for online manuals.
This manual covers the following Informer devices:
• Informer-IP Desk Mount (I-IP-IO)
• Informer-IP Wall Mount (I-IPW)
• Informer15 Speaker (I-IP15 and I-IP15X)
• Informer100 Speaker (I-IP100AC, I-IP100DC, I-IP100ACX, and I-IP100DCX )
• Informer-PA for Public Address Interface (I-IP2)
• Informer Sensor Interface Unit (I-IPSIU)
Federal Signal Informers can be set up in a wide variety of networks and configurations.
This manual provides a standard setup and programming process for Informer products.
See the Commander Software Reference Manual or contact Federal Signal for special
applications using Informer devices. Appendix B contains configuration tables for
documenting how your Informers and Commander are programmed.
This manual does not pertain to Informer Series A or B products. See “Getting Service”
on page 80 for Federal Signal’s contact information for Series A or B I-IP15 upgrade
instructions. Other Series A or B Informer models are not hardware compatible with
Series C software.
