- 22 -
Using a Pager (cont)
2. Enter your new pager phone number. Your new pager phone number may
consist of up to 16 characters (1-9, 0). It may be necessary to add time to
allow the pager to answer before dialing your pager number. To enter a 2-
second pause, press the [Code] key. (Entering a 2-second pause is optional
and is not required to enter your pager phone number.) If the [Code] key
was pressed, it counts as one character. The keypad will emit a single
acknowledgement chirp as each number is pressed.
3. Press the [#] key after you have made your pager phone number changes.
Pressing the [#] key saves your new pager number and nulls out the
remaining locations. An acknowledgement tone sounds.
To exit without saving changes, press the [
✴
] key to exit pager phone number
programming. An acknowledgement tone sounds to indicate pager number
programming has been exited.
If you press the [
✴
] key without first pressing the [#] key to save your new pager
phone number, the system exits the pager phone number programming mode
without saving the changes.
If no key is pressed within 10 seconds, the pager phone number programming
mode times out and exits automatically without saving any information entered.
TURN PAGER REPORTING ON/OFF FOR THE PARTITION
You can turn on/off the open-close reporting feature for a partition by pressing
#
,
8
. The display prompts you to toggle the feature on/off with the [#] key.
To exit, press the [
✴
] key.
TURN PAGER REPORTING ON/OFF FOR A USER
You can turn on/off the open-close reporting feature for a user by entering the
following :
#
,
7
, [master code] [user number] [4]
NOTE:
The
#
,
7
command is also used to assign a user to a different
partition (see ASSIGNING PARTITIONS TO USERS on page 14).
