9
FBD
FWD
BACK
SELECT
CANCEL
OFF
RIGHT SIDE
FILL
BEATER
RUN
DEF.
LEFT SIDE
FILL
BEATER
RUN
OFF
DEF.
CENTER
FILL
BEATER
RUN
OFF
DEF.
SIDE 1 STATUS
MODE DISPLAY
SIDE 2 STATUS
Figure 7.2
NOTES
optimize the operation of the machine. Incorrect settings at this level could
prevent the machine from operating properly or cause damage to the unit.
Included in this level are various accumulated totals and diagnostic tools that
help the technician evaluate problems.
NOTE
To access the Service Menu, press the FWD button on the control panel until “SERVICE
MENU” displays. Press the unmarked button on the right side of the panel. The service
menu has been accessed when “MACHINE SETTINGS” displays. Press FWD to access
other options.
E. How to Access and Change Values
The same procedure for changing values applies to all access levels. The following steps allow
the parameters of the control system to be monitored and changed.
1.
The current mode is displayed in the lower half of the LCD. Press the FWD button to step
to the next mode. Continue pressing the FWD or BACK button until the desired mode is
displayed. When the desired mode is displayed, press SELECT to enter the mode.
2.
To make changes to the displayed mode, press the SELECT button. When a value in the
lower half of the display begins to flash, this indicates that the value can be changed.
3.
To change the value, press the FWD button to increase the value or the BACK button to
decrease the value. Any on/off functions can be changed by pressing the SELECT button.
4.
Once the desired value is displayed, press the SELECT button to enter the value into the
computer. Pressing the SELECT button will stop the display from flashing. When the value
stops flashing, it has been changed.
NOTE:
When entering TIME, WAKE, or SLEEP functions, both the hours and minutes must be
selected before the computer will accept the change. For the Defrost Times, days in upper
case (capitals) are selected. Days in lower case are NOT selected.
