Part No. SCAZ042891 1.3.4
20
E&OE
Operating Instructions Scarab M6
Rear Door Operation
Ensure that all personnel are clear of the rear door and there is enough room for it to
open fully.
Ensure that the suction fan has been switched off.
When working with the door in the fully raised position ensure that the door safety prop
has properly deployed.
To open and close the rear door, proceed as follows:
1. Ensure the machine correctly positioned with plenty of room for door to open fully.
2. Turn vehicle engine off. Parking brake engaged. Vehicle in neutral.
3. Multi function lever off. See page 12.
4. Auxiliary engine on. See page 16.
5. The safety interlock button
needs to be pressed and held in while using other buttons
on the remote control.
6. Open rear door by pressing and holding
until fully open.
7. Insert the rear door safety prop if working around or under the rear door.
8. Ensure that the rear door seal and its mating surfaces on the hopper are free from any
foreign matter that might damage the seal or adversely affect the sealing function.
9. Remove and stow the rear door safety prop.
10. Close rear door by pressing and holding
, the auxiliary engine speed will raise to
1500rpm, the auto blanking flaps will close and the suction fan will switch on. Continuing
holding
until the rear door has fully closed and the door locking mechanism has fully
engaged.
Releasing the close button will switch off the suction fan and engine speed will fall to
tick-over after a small delay.
This has been done to create a vacuum in the hopper which will help close and seal the rear
door.
The rear door will not close via the remote control unless the hopper is in the fully down
position as determined by the hopper down sensor.
When inserting the
door prop, ensure it
is correctly positioned
in the locating slot
Rear Door Prop
