Part No. SCAZ042891 1.3.4
12
E&OE
Operating Instructions Scarab M6
Auxiliary control panel switch functions
HIGH-PRESSURE WATER PUMP (Option)
- Press to start.
SUCTION FAN
- Press to start the Suction Fan (approximately 1650 RPM).
NOT APPLICABLE
NOZZLE TILT (LOCKING MODE)
- Press to tilt the suction nozzle for larger items.
SUCTION FAN ‘BOOST’
- With the Suction Fan ON, press to activate the fan boost mode
(approximately 2336 RPM).
FAVOURITE SETTING
- Press to memorise your preferred sweeping set-up. Hold the switch down
until a ‘beep’ sounds. Thereafter, whenever the switch is pressed at system start-up, the
memorised configuration will be automatically pre-selected/restarted. Repeat to over-ride with a
new configuration.
MULTI - FUNCTION
LEVER
- ON (deploys all selected sweeping equipment). To stop and raise all
sweeping equipment, return the lever to the OFF position. In the ON position the lever can be used
to control the side brushe(s) and suction nozzle(s). These additional positions i.e. Left, Right and
Back, return to the central position when released.
The brush and nozzle functions are controlled as follows:
ON LEFT HAND DRIVE MACHINES
Move the lever to the left to swing OUT and to the right to swing IN the side brush(es).
ON RIGHT HAND DRIVE MACHINES
Move the lever to the right to swing OUT and to the left to swing IN the side brush(es).
NOZZLE-TILT FUNCTION
Move the lever back to momentarily tilt the suction nozzle or close it from TILT OPEN position.
ON
OFF
SIDE BRUSH
SIDE BRUSH
TILT
NOZZLE
MULTI-FUNCTION
LEVER
