2
www.fastTT.bike
FastTT Aero Bar Installation Guide - TKP v8
Congratulations on purchasing your FastTT Aero Bars!
The following pages will guide you through the installation process.
Please read the instructions from start to finish BEFORE commencing installation.
It is important to follow the installation sequence.
You WILL require a second person to assist with marking and holding. Installation might take
around 1½ to 2 hours.
TOOLS REQUIRED
•
Fine tip felt marker pen
•
Power drill
•
2.5mm metal drill bit (cobalt recommended)
•
6mm or 7mm metal drill bit, depending on bolt diameter (cobalt recommended)
•
Torque tool
•
Hacksaw or Dremel cutting tool
•
Electrical tape and masking tape
•
Spirit level (if measurement jig not available)
•
Measuring tape
IMPORTANT NOTE!
Installing
FastTT Aero Bars
requires a little more technical knowledge and attention to detail than
fitting standard bolt-on TT/Tri bars. We STRONGLY RECOMMEND using a bike mechanic or bike fitter
that has experience with TT/Tri bikes and is familiar with setting up to meet UCI regulations.
If you are not confident using workshop tools or carrying out technical repairs to your bike, please
have a qualified bike mechanic or bike fitter install your
FastTT Aero Bars
. They are a big investment,
and we would not like you to damage them through incorrect installation (and void your warranty).
INTRODUCTION
