12
www.fastTT.bike
FastTT Aero Bar Installation Guide - TKP v8
Carefully drill the holes with a sharp metal drill bit. Drill the hole at a similar angle to your
chosen mounting angle. If you notice carbon splinters around the hole, deburr them as much
as possible before fitting.
Refit your spacers (if applicable) and then bolt the bars to the bike by inserting the mounting
screws through the REAR holes.
If you are using spacers/angled mounting wedges, you will need to purchase countersunk Allen
head screws of an appropriate length and thread diameter (M5 or M6) to suit your setup. Most
countersunk screws are available from a nut and bolt supplier. We stock a comprehensive
range of long mounting bolts:
https://www.fasttt.bike/product-category/mounting-bolts/
Lightly tighten and adjust the
inwards/outwards angle to your
preferred position. Once this position
is established, mark the hole for the
FRONT mount screw onto the grid
sticker from BELOW.
Remove the bars and spacers from the bike and repeat the drilling process you used for the
rear hole (drill 2.5mm pilot hole from bottom side, cut out 10mm Velcro, carefully drill a 6mm
or 7mm final hole, depending on screw thread diameter).
Refit the bars to the bike and tighten lightly. Recheck your measurements to ensure UCI
compliance.
SECTION C - MARKING AND DRILLING THE MOUNTING HOLES