16
www.fastTT.bike
FastTT Aero Bar Installation Guide - TKP v8
TAPING THE BAR ENDS
Start your bar tape at the base of the finger hook and
wind it downwards. Trim the tape at an angle at the
collar and apply a layer of electrical tape, half across the
tape, half across the collar. The tape should finish flush
against the collar.
UCI/ISO CERTIFICATION
FastTT aero bars have been tested and certified to the ISO-
4210 standard required for use in UCI sanctioned events.
The certification sticker with test reference number is on
the underside of each bar. DO NOT remove this sticker.
IMPORTANT!
Whilst every care has been taken to ensure the information in this installation guide is accurate
and correct, UCI regulations and rules are reviewed and updated from time to time. It is the
customers sole responsibility to ensure that you are familiar with the latest rules and
regulations regarding the use and fitment of aero bars and associated components. UCI
technical equipment rules are available here:
https://www.uci.org/equipment/bh2JJzw1eB0n876rX2iB1
SECTION E - FINISHING OFF
IMPORTANT SERVICE NOTE!
After a few rides we recommend that you check and retighten the mounting bolts on your FastTT
Aero Bars. The bolts can become slightly loose after initial riding due to natural bedding in of the
bolts into the carbon mounting base. This can potentially cause a small amount of lateral movement
in the bar. If this occurs, please retighten to a maximum of 4nm. We also recommend applying a very
small amount of thread lock to the bolts before refitting them. If at any stage you notice lateral
movement of the bar you should retighten the bolts.
