Fastech Ezi-SPEED ESD-30-C, Manual

Page: 70 / 93

-70-
8.3 Parameter list
Item Display Description Setting range
Factory se
tting
Acceleration time Pr.tA Sets the acceleration time 0.0 ~ 15 s 0.5 S
Deceleration time Pr.td Sets the deceleration time 0.0 ~ 15 s 0.5 S
Torque limit Tq.LM Sets the torque limit 10~300 300
Overload alarm detection
time except when holding a
shaft
oL.tM
Sets the time to output the alarm afte
r detecting the overload condition wh
en a load up to the limited duty regio
n exceeding the continuous duty regi
on was applied.
0.1 ~ 60 s 40 S
Speed upper limit SP.Hi
Sets the upper limit of the rotation
speed
50 ~ 4000 rpm 4000 rpm
Speed lower limit SP.Lo
Sets the lower limit of the rotation sp
eed
50 ~ 4000 rpm 50 rpm
Speed reduction ratio Gr-r
Sets the speed reduction ratio relative
to the rotation speed of the motor
output shaft. Displays the speed
calculated based on the speed
reduction ratio on the monitor mode.
If the speed reduction ratio for the
conveyor is calculated and input, the
conveyor speed can also be
displayed.
1.00 ~ 9999 1.00
Speed increasing ratio SP-r
When increasing the motor rotation
speed using the external input, the
converted speed can be displayed.
1.00 ~ 2.00 1.00
Panel initial display P.dSP
After the power is turning on, the ite
m displayed on the monitor mode ca
n be changed.
SPd – Rotation speed (r
/min)
Load – Load factor (%)
oP.no – Operation data
number
SPd
Prevention of operation
at power–on alarm
oP.AL
Sets whether to enable or disable the
“prevention of the operation at powe
r on alarm”
on – Enable
oFF – Disable
on
External input function io.En
The operation method can be selecte
d between the front panel and extern oFF – Disable
on – Enable
oFF