Fastcorp, LLC
DIVI Setup and Users Guide
Page
39
of
62
Rev 6
Gently, press down on the Micro SD
card so that it locks into the slot. The Display will scroll between the options on the
Micro SD Card menu:
1.
Load Config.
2.
Save Config.
3.
Load Firmware
4.
Save DEX Sales
Press “3” to load new firmware.
Use the asterisk “*” key
to scroll through the contents of the Micro SD card. Scroll to the latest or highest number version.
The program version will be displayed in the “FC0xxxy.bi2” format, where “xxx” is the numeric revision number and
“y” is the alphabetic revision suffix. For example, FC0124J.bi2.
Press the pound (#) key
to enter the selection. The Display will read, “Programming”. An LED status light on the right side
of the VMC Board will start flashing rapidly. When the process is complete, the display will read, “UPDATE SUCCESS.
Remove card…”
To remove the Micro SD card
, press down on the top of the card. It will slide up enough for you to lift the card straight up
and out.
Notes -
a)
Power does NOT have to be turned “OFF” to remove the SD card.
b)
The vacuum may produce a clicking sound during this procedure. This is normal and is not a concern.
c)
A major firmware upgrade may require the Robot Arm to be re-calibrated. Please refer to the section,
“Calibrating the Robot Arm” in your manual. Scroll to Service Menu Option “4) Create Selection”, Press “#” and
follow the prompts to calibrate the Robot Arm.
d)
Your programming data will need to be re-entered after this upgrade. Go to Service Menu Option 4) Create
Selection, Press “#” and follow the prompts to program your machine. Going forward, the data will be saved and
automatically re-installed as part of the upgrade process.
You can save a copy
of your bin configuration onto your Micro SD Card as a backup file or to use to program other
machines. Insert the card into the slot on your board after programming your first machine.
A.
Press “2” to “Save Config”.
B.
Choose a name for your bin configuration and save the file onto your Micro SD card (see Fig.
12 in the next section). Remove the card from the daughter board.
C.
To upgrade additional machines install the Boot Loader and Program Upgrades per
instructions. To install the bin configuration, insert t
he Micro SD card, Press “1” to “Load
Config”. Use the * key to scroll through the configuration files then press # to install the bin
configuration for your machine.
D.
Go to Menu 22) Verify Bins to confirm accuracy. Make adjustments if necessary.
Contact Fastcorp Tech Support at 888-441-3278 if you have any questions.
