LOKAL 400 Operating Manual
Page 16
7.3.2. Signal amplification
If you wish to set the amplification level of the corresponding entries, please tap on the
”Level“ button [4]
in the correlation main window. A new window is opened up where you can adjust the requested
amplification level with the dial or with the touch function.
NOTE:
Amplify the noise level so that the bar of the noise level indication [1] fills about half of the indication
box.
TIPP:
If you press on this
button in the window or on
the “Measurement box” button [2], the
LOKAL 400 system will automatically adjust the amplification level.
7.3.3. Correlation results
If a measurement is stopped either after the maximum average determinations have been completed (50
determinations in the automatic mode and 250 determinations in the manual mode) or by tapping on the
“Stop” button during a measurement procedure, the system allows navigating inside the displayed result
image by selecting the correlation result with the dial or by tapping on the button. Inside the window, the
following selection options are offered:
[1] Correlation image between signal A and signal B
[2] Correlation peak (red line)
[3] Zooming out
[4] Displaying the entire image
[5] Zooming in
[6] Searching for the maximum value
