Fast & Fluid Management SK450, Manual

Page: 16 / 21

Fast & Fluid Management B.V. – SK450 / SK550
V. 04 ‐ 2013 P16
Error codes
Error Cause Action
E01 Clamping motor power too low or bad
electric wiring
Call service
E02 Preset minimal clamping pressure not
reached Call service
E03 Door opened during mixing or door
switch defective Keep door closed during mixing. If
persistent, call service
E04 -
E06 SK550 Mainboard 5V or 12V circuitry
overload Call service
E07 Clamping plate reached minimal position Place (taller) can
E08 Can shrunk during mixing Use less fragile can
E09 Component overload Call service
E10 No pulses received from encoder Call service
E12 T5 (turbo FET) of 100V power supply
defective
Call service
E18 Clamping plate risen or loosened during
mixing Check can position
E20 -
E33 SK550 Mainboard component overheat
(> 90° Celsius) Pause for cooling, check machine
ventilation. If persistent, call service
E41 EEPROM read error Allow reset to default settings. If
persistent, call service
E71 SK550 Mainboard defective (T7 of T10) Call service
E89 SK550 Mainboard defective (T8 of T9) Call service
E99 Shake motor or wiring short circuit Call service
E100 SK550 Mainboard defective (main motor
power feed) Call service
E101 Power supply from wall socket too high Check mains. If persistent, call service
E102 Power supply from wall socket too low Check mains. If persistent, call service
Service and Support
If necessary, you can get in touch with your supplier or the local service department, or
contact the manufacturer directly. If you contact the manufacturer, make sure that you have
the model number and serial number to hand. They can be found on the nameplate on the
machine.
For more information please visit our website www.fast-fluid.com