Fast & Fluid Management SK450, Manual

Page: 15 / 21

Fast & Fluid Management B.V. – SK450 / SK550
V. 04 ‐ 2013 P15
Clamping plate will not go
down Clamping plate jammed Use interface user setting U4
Fuse blown Shut power off and replace fuse
Machine starts shaking
before the container has
been clamped
Too much spindle resistance Clean the spindles and lubricate
Clamping plate incorrectly set Call service
Clamping plate goes down
and back up again without
mixing
Container is too low Use taller container
Container is too weak (crushed) Use stronger container or adjust
clamping force Call service
Too much mechanical resistance Clean the spindle and lubricate
Clamping plate will not go
up after mixing
Clamping plate is jammed Use interface user setting U4,
as explained on 26.
If persistent, call service
Container unclamps while
mixing
Container(s) not centered Replace container(s) in
gravitational centre.